Yanhua BMW ID7 Special CAN Filter for G-Series Full LCD Cluster Mileage Correction
Yanhua ACDP / ACDP Adapters & Cables
The Yanhua BMW ID7 Special CAN Filter is the missing link for clean mileage correction on BMW G-series full LCD instrument clusters. After you adjust the ID7 odometer with a YH35XX programmer, the IMMO module (BDC2/BDC3) will try to push the real mileage back to the cluster – this filter stops that sync so your corrected value stays put.
Key features
- Plug-and-play – no soldering, no chip removal, no risk
- Prevents IMMO module (BDC2/BDC3) mileage from re-syncing to the ID7 cluster
- Also resolves the well-known ID7 dark / black screen issue
- Does not affect start-stop or maintenance mileage
- Installs in minutes between the original instrument plug and harness socket
Supported models
- BMW 2019+ 5 / 7 / X5 / X7 Series
- BMW 2020+ 3 / X3 / X4 / X6 Series
- Any other BMW G-chassis vehicle with an ID7 full LCD instrument
Important notes
- This filter does NOT freeze or stop mileage from running – it only blocks the post-correction sync
- Does not support BMW hybrid models
- ID7 / ID8 clusters use 35160 or 35128 EEPROM (not 160DOWQ / 160DOWT)
- Works with the Yanhua YH35XX Programmer + Simulator for the actual mileage correction
Installation
- Separate the shell from the original instrument plug
- Install the plug shell onto the filter
- Plug the filter into the instrument socket
- Plug the filter pin into the instrument harness socket
What's in the box
- 1 x Yanhua BMW ID7 Special CAN Filter
