CGDI CG100X Programmer – Airbag Reset, Mileage Correction & Chip Reading (with PRO V2 Harness + D1 & D2 Adapters)

The CGDI CG100X is a next-generation programmer built for repair shops and locksmiths, covering roughly 90% of the vehicles and modules on the market — American, German, French, European, Korean, Japanese, Italian, and domestic makes, plus engineering vehicles and motorcycles. Stable, fast, and shop-ready.

Core functions

• Airbag reset — 4,500+ ECU models. Two approaches: fault-code clearing (keeps original data) or full data overwriting. Strong coverage of R7F7, D70F, and SPC airbag units, including 8-pin chips without desoldering.
• Mileage correction / dashboard — 4,600+ models with a 95%+ success rate and an intelligent algorithm (error within ~32 km). Includes VW/Audi MQB-platform mileage repair (via D70F3526 / D70F3529 / D70F3532 clusters), covering common US-market models such as Golf/GTI, Jetta, Tiguan, Atlas, and Arteon. Some hybrids support HEV+EV editing; engineering vehicles support working-hour edits.
• ECU & BCM repair — engine computers, steering angle sensors, FRM modules, keyless-entry modules, audio amplifiers, transmission computers, and 12V/48V lithium battery modules. Includes Mercedes-Benz 48V battery repair, BMW FRM and Porsche 12V solder-free adapters, and BMW 35080-series support.
• Chip read/write (Programmer) — covers 90%+ of common automotive chips and 1,800+ models: read, modify, write, erase, and partition.
• Key matching — BMW CAS series and Land Rover, with automatic key ID and usage-status display.

Why the CG100X

• 120%+ faster chip read/write than typical programmers (up to 200% on some chips, 500%+ on large-capacity 8-pin chips).
• 8-pin reading with no desoldering, plus live pin-contact detection (red = poor, green = good) to protect chips and data.
• DB25 connection with clearly numbered, labeled harnesses to prevent wiring errors; supports CAN, LIN, and K-line protocols.
• Software opens without the device connected, so you can check model/function coverage before you start a job.

Supported EEPROM / MCU families

24, 25, 35, 93, 95, X50, S29, RH, CAT10, CR series; MB90/MB91/MB96; PIC18F; TI TMS; S32K1; 9S08, 9S12, HC908, HC912, MAC, MPC56; ATMEGA; H8SX, M32R, R5F10D, RH850, V850; TC, XC; ST (SPC, ST10F, STM32F, STM8); Cypress/Spansion S6J.

Updates & language

One year of free software updates included; renewals are $89/year afterward. The device keeps working even if you don't renew. Interface language: English / Chinese.

What's in the Box

CG100X main unit · EEPROM holder · 2× EEPROM adapters · 35X-CAN adapter · 12V power adapter · USB cable · CAN cable · EEPROM soldering cable · EEPROM clip · PRO V2 cable · D70F34xx/D70F35xx adapter · CG100X D1 adapter · CG100X D2 adapter · CG100X PRO V2 harness.